The demand control is an extension of the vs | plus idle state. Each partial node can be switched to a demand stage (e.g. main direction dark, secondary direction flashing yellow) after reaching sleep mode. Only when a request is made is vs | plus woken up and resumes normal operation.
|
Display |
Identifier |
Values |
Description |
|
Active |
|
|
vs | plus only allows 8 switch-on definitions and therefore only 8 different switch-on triggers per program. But since you have the possibility to define as many as you like via the flags, you have to define here which of them you want to use. By default, simply the first 8 sequences are marked as active. |
|
|
|
|
|
|
|
|
1 .. 8 |
A maximum of 8 switch-on definitions are permitted. |
|
Priority |
Priority for concurrent occurrences |
|
It may happen that two triggers are detected simultaneously (in the same processing cycle). If you want to prioritize the switch-on sequences accordingly, you can determine the sequence here. |
|
|
|
|
|
|
|
|
1 .. 9999 |
1 = highest priority, 9999 = lowest priority. |
|
Trigg. TS |
Triggering traffic stream |
|
Shows the traffic stream trigger which initiates the switch-on sequence. In case of a switch-off definition, this column is empty. |
|
|
|
|
|
|
DispE. |
Display element |
|
Shows the display elements for which the stage of the switch-on or switch-off sequence can be defined. In each case, all display elements of the sub-node, of the display type signal group, are listed. |
|
|
|
|
|
|
Seq. x |
|
|
Here the switch-on or switch-off sequences are defined. For this you must divide your states, which you want to run through sequentially, into a maximum of 5 partial sequences and then define the state and duration for each. |
|
|
|
|
|
|
|
|
None |
No definition |
|
|
|
Close |
Color image that is defined as a close. |
|
|
|
Open |
Color image that is defined as open. |
|
|
|
Off (Yellow) |
Permanent yellow |
|
|
|
Off (yellow flashing 1Hz / bright starting) |
Yellow flashing 1 Hz bright starting |
|
|
|
Off (yellow flashing 1Hz / dark starting) |
Yellow flashing 1 Hz starting dark |
|
|
|
Off (yellow flashing 2Hz / bright starting) |
Yellow flashing 2 Hz bright starting |
|
|
|
Off (yellow flashing 2Hz / dark starting) |
Yellow flashing 2 Hz starting dark |
|
|
|
Off (off) |
Dark |
|
Duration x |
|
|
Duration of the defined sequence x. Is the same for all display elements. |
|
|
|
|
|
|
|
|
1 .. 3000 |
Time in seconds. |
|
Parameter |
from vs | plus version |
Comment |
|
Control on demand |
9.0.0 |
Is only included in vs | plus as of this version. |